Beautifully display those farm fresh eggs with these DIY Wooden Egg Holders. Decorative, useful and would make a stunning DIY gift!

TOOLS AND SUPPLIES - Ryobi’s plunge router with adjustable speed settings - Roman carbide DC1065 1-1/2″ round nose router bit - 1/2″ round over router bit - Router table – Palm sander with 100 grit paper – Straight edge – Scrap wood and clamps to hold it in place

INSTRUCTIONS: Start by deciding what length you want to cut the board. For six eggs I cut the board 7 1/2 inches long.  Add two inches for every pair of eggs after that.

Then cut the board to 4 1/2″ wide. Make your first mark on the board at 1 3/4″ then two inches for every egg pair after that. 

I used a speed square to extend the marks across the full face of the board. This will help to keep the router lined up on each row.

In order to clamp the board I had to get a little creative since most of my woodworking supplies are in storage.

Click below for my full post with tips!

For more tips and recommendations visit