DIY Cell Phone Stand And Accessory Holder

Knock the socks right off your man by surprising him with this stunningly simple DIY Cell Phone Stand and Accessory Holder. Or . . . send him straight to this tutorial to make one for himself!


– Wood Glue – Wood clamp – Wooden Dowel pieces – Piece of wood cut to the size you want – Drill with drill bit


To mark where you want to drill the holes for the dowels, use the smaller piece of wood already cut, which was approximately 3/4 inch. Line up the smaller piece with the bottom of the larger piece and use a pencil to mark.


Then line up the same piece of wood on the long side of the larger piece and mark a line so that the two lines cross.


Repeat on the other side.


Clamp the smaller piece to the front of the larger piece so that there is an 1/8 of an inch distance from the bottom of the large piece. This will allow you to drill through the larger piece and into the smaller piece at the same time.


Drill the holes at approximately a 15 degree angle so that the drill bit enters the center of the smaller piece that is clamped in place.


You don’t have to drill all the way into the smaller piece, just be sure you mark it with the drill bit so you know where to finish drilling those holes.

Swipe up for more!